Commercial Fabrication Shop

Over the last week we have been very busy. Sorry we haven’t had time to post anything during that time. We have been installing large commercial equipment for a Fabrication Shop.

This De-burring machine is 3 phase 480v 70 amps. The machine was moved to a new location and we had to rewire it and get it working. We didn’t have a lot of time to do it being that the owner had a large order to complete. We had to remove a section of the power run and relocate it with an additional 40 ft. of conduit and wire. We installed pull boxes at two locations and attached everything to the ceiling using existing unistrut and we added several feet as well. The main sub-panel was not marked correctly so that added a little time to the project just trying to figure out which phases were going where. In the end we had the machine up in two days.

We also added a circuit for a cutting machine that took us a little over a half day to complete.

If you need an help with your electrical in Southern California, call us. 951-522-6530

We are located in Beaumont, CA and service Inland Empire and Coachella Valley from the Salton Sea to the Orange County line. That includes; Beaumont, Banning, Palm Desert, Riverside, Yucaipa, San Bernardino, Palm Springs, Indio, Upland, Redlands, Rancho Mirage, Colton, Cabazon, Premium Hills Outlets and Cathedral City.

 

Leave a Reply

Your email address will not be published.