Roberto Cavalli Install

We have been contracted to install the electrical and low voltage at the new Roberto Cavalli store at the Premium Hills Outlets. It has been a six week project and it is nearly complete. We started the rough back in May and have been on site with our crew since the project began. We have had a few bumps here and there along the way but it all worked out as it usually does when we submit every day to the Lord Yeshua! We begin everyday in Word and prayer for everything from safety to protection and everything in between.

Existing Panel

The existing panel was from the prior tenant. Some of our circuits were already run through existing conduit along the ceiling of which we were able to use for some of our front of house electrical runs however, we had to get the wires into the panel from above and from the automated panel that we removed which was right next to the panel we were going to use. It was a large process to move the existing circuits into the “new” panel and then insert the existing runs that were over to the panel through conduits. So, we installed j-boxes 13′ above floor finish (AFF) and connected them into the panel with 3/4″ and 1″ conduit runs. We ran new conduits down the wall attached to unistrut and into the panel where we were able to connect our runs in the j-boxes. We did other things to get it done but the blessing with this process is that we were able to use the existing panel to lengthen some of our wires with wire nuts in order to make it to the breakers. Much like a large junction box.

If you need an help with your electrical in Southern California, call us. 951-522-6530

We are located in Beaumont, CA and service Inland Empire and Coachella Valley from the Salton Sea to the Orange County line. That includes; Beaumont, Banning, Palm Desert, Riverside, Yucaipa, San Bernardino, Palm Springs, Indio, Upland, Redlands, Rancho Mirage, Colton, Cabazon, Premium Hills Outlets and Cathedral City.